RMSTATOR New Aftermarket Ski-doo Kit Stator + Flywheel + Gasket + Cap Coil, RM22871

Brand new, Rmstator Kit Stator + Flywheel + Gasket + Cap Coil.

Brand New Kit Stator + Flywheel + Crankcase Cover Gasket + Ignition Cap Coil

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• All shipped products are tested

*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

• Highest grade of lamination materials
• Highest grade of copper winding, resistant to 200 degrees Celsius
• Connector included
• Rubber grommet included
• Crankcase cover gasket included

• The Quality exceeds the OEM equipment
• 1 Cap coil included

If your old parts are defective, RM Stator offer replacements parts of high qualities at a fraction of the cost of genuine parts.

*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.

Some Ski Doo models combine the spark plug caps and coils to reduce the number of parts used to improve efficiency. However, when your plug caps wear out is more expensive to replacing them. If you are experiencing ignition problems this could mean the coil plug cap needs replacing. The replacing was simple to do and help with the efficient running of your engine.

RMSTATOR is offering a new replacement flywheel for your Ski-doo. This flywheel can be used as a direct replacement to the OEM.

What is improved about the RM11503 flywheel?

Ski-doo 1200 snowmobiles are plagued with problems on the original flywheels. The additives in the motor oil were dissolving the epoxy that holds the magnets in the flywheel, causing them to detach and scatter throughout the engine.

The bad news is that by the time the problem occurred, no manufacturer would provide warranty repairs.

The good news is that RMSTATOR has manufactured a redesigned flywheel where the magnets are sealed in the flywheel, which reinforces the epoxy and prevents them from detaching. This new flywheel configuration corrects the problem permanently.

Dealership estimates to repair this failure are over $500 in parts alone. RMSTATOR offers you a high quality replacement part that corrects the problem for half the price. The RM11503 flywheel is not only a cost effective way to replace your failed Ski-doo flywheel, but a great investment when replaced before the failure occurs.

SEAL THAT PROTECTS THE MAGNET�S EPOXY FROM OIL ADDITIVES

Stator Dimensions
Interior diameter: 42 mm
Exterior diameter: 114 mm
Thickness: 19 mm
Length of wires stator to grommet: 110 mm
Length of wires grommet to plug: 600 mm

Other specifications:
Number of wires: 3
Number of plugs: 1
Number of pins: 3

Wire to wire resistance:
Alternator: Between each Yellow = 0.4 ohms +/-20%

Ignition Cap Coil Dimensions
Internal tube diameter : 22 mm

Flywheel Dimensions:
Exterior Diameter: 129 mm
Interior Diameter: 116 mm
Interior Diameter Center Housing: 30 mm
Exterior Diameter Center Housing: 38 mm
Thickness (exterior): 7 mm
Thickness (interior): 7 mm

OEM Replaced SKUs

• Sold Each

SKU# RM22871

Fits: