RMSTATOR New Aftermarket Ski-doo Stator + Flywheel + CDI Box Calibration Module fits on 1 cylinder, RMS900-107040

Brand new, Rmstator Stator + Flywheel + CDI Box Calibration Module fits on 1 cylinder.

Brand new aftermarket Stator + CDI Box Ignition Coil Calibration Module + Flywheel Kit

• All products shipped are tested

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Connector included
• Back Plate included

• Our part is a Plug-and-play unit, direct fit, and easy to install
• Enhanced timing curve, increased rev limiter (approximately 1000 rpm)
• Higher grade of electronic components
• The Quality exceeds the OEM equipment

This flywheel can be used as a direct replacement to the OEM.
Stator Dimensions:

Interior diameter: 43 mm
Exterior diameter: 110 mm
Thickness: 32 mm
Length of wires clamp to plug: 500 mm

Other specifications:
Number of wires: 6
Number of plugs: 1
Number of pins: 6
Number of poles: 12

Wire to wire resistance :
Alternator: Yellow between each yellow = 0.4 ohms +-20%
Alternator to ground = O.L
Source: Red to black = 8 ohms +-20%

Height: 44 mm
Length: 94 mm
Width: 48 mm
Fixation holes center to center: 72 mm

Other specifications:
Number of plugs: 3
Number of pins: 9

Please note that: The only real way to test your CDI box is to swap it out with another known good unit from the same year / make / model. Because of this, we recommend that you rule everything else out before replacing the CDI box.

Exterior Diameter: 117 mm
Interior Diameter: 96 mm
Interior Diameter Center Housing: 24 mm
Exterior Diameter Center Housing: 35 mm
Thickness (exterior): 46 mm
Thickness (interior): 23 mm

OEM Replaced SKUs

• Sold Each

SKU# RMS900-107040

Fits: