RMSTATOR New Aftermarket Yamaha Kit Stator 200 W + Regulator Rectifier + Performance CDI + Ignition Coil + Flywheel, RM22846

Brand new, Rmstator Kit Stator 200 W + Regulator Rectifier + Performance CDI + Ignition Coil + Flywheel.

Brand new HO Stator + CDI Box + HP Regulator rectifier + Flywheel + External ignition coil Kit

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• All shipped products are tested

*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

• Highest grade of lamination materials
• Highest grade of copper winding, resistant to 200 degrees Celsius
• Pick up pulsar coil included
• Connector included
• Rubber grommet included
• Adjustable timing plate to advance and retard up to 10 degrees included

• 12 Volts regulator used by Baja winners
• For use with all standard halogen and quartz lights
• Precise voltage control, eliminates light burnout
• Reduce flickering and dimming
• Simple installation
• Works with all other OEM parts
• Rated at 225 watts

• Enhanced timing curve, increased rev limiter
• Higher grade of electronic components
• The Quality exceeds the OEM equipment

RMSTATOR is offering a new replacement flywheel with stronger magnetsfor your YAMAHA YFZ350 BANSHEE, this flywheel can be used as a direct replacement to the OEM.

We suggest combining it to our 100 or 200 watt stator as it will run the lights better in the lower rpm's.

• The Quality exceeds the OEM equipment

• Highest grade of lamination materials
• The Quality exceeds the OEM equipment
• Spark plug cap(s) included

If your old parts are defective, RM Stator offer replacements parts of high qualities at a fraction of the cost of genuine parts.

Other specifications :
Number of wires : 6
Number of plugs : 3
Number of pins : 6

Wire to wire resistance :
Alternator : Black to Yellow = 0.2 ohms +/-20%
Pickup : White/Red to White/Green = 100 ohms +/-20%
Source : Red to Green = 15 ohms +/-20%

CDI Box
Number of plugs : 2
Number of pins : 8
Height : 25 mm
Lenght : 85mm
Width : 71mm
Fixation holes center to center : 85mm
Wires lenght : 120mm 140mm

Flywheel
Exterior diameter : 128mm
Interior diameter : 105mm
Interior diameter center housing: 21mm
Exterior diameter center housing : 34mm
Thickness Exterior : 12mm
Thickness Interior : 7mm

External ignition coil
Bracket center to Bracket: 90mm
Wires lenght : 590 mm
Primary Resistance: 0.4?
Secondary Resistance: 6.0K?
Damped Resistance: 5K
Voltage Transfer Ratio: 150:1
Insulation Resistance: >1000M

OEM Replaced SKUs

• Sold Each

SKU# RM22846

Fits: